หน้าแรก|กระดาน|รีวิว|ประมูล|ตลาด|เปิดท้าย

Begin by taking the spool out to reveal the spool bearings.

Bearings unshielded and degreased, these have seen some wear but are still capable of spinning for at least 20 seconds at a flick of a finger - pretty good results for unrated bearings! I used a light oil to lubricate them.

In case you want to change them out to faster grades or ceramics, the Smaller Spool Bearing is 10 x 3 x 4mm (OD x ID x Thickness); the Bigger Spool Bearing is 11 x 5 x 4mm.

The 3rd high speed bearing (8 x 3 x 4mm) is behind the Cast Control Knob. This one has press in shields so I didn't try removing them, but degreased and re-lubed with a light oil.

The Worm Shaft is supported by this tiny 7 x 4 x 2.5mm Ball Bearing. I didn't attempt the pry out the shields as they were not replaceable. Lubricated with Corrosion X and slip into the big end of Level Wind Tube.

9 x 5 x 3mm Gear Shaft Support Bearing's shields cannot be re-fitted so I oiled with Corrosion X and filled the Bearing housing on the frame with grease.

The smaller screw at 8 o'clock position is very very long……………………….. I wonder why it need to be that long. You screw and screw it in (or out) and it is still not there yet! I've heard that some people get a blister from this protruding screw.

Oil 8 x 3 x 4mm Cast Control bearing with a light oil and install.

น้าๆท่านไหนอยากชม แบบจัดเต้ม ชมได้ที่นี่เลยคับ http://alantani.com/index.php?topic=6260.0 ผมเอามาให้ทราบแค่ขนาดลูกปืน ที่จะโมกันแค่นั้นคับ เพราะโดยส่วนตัวผมผมมองว่า รอกBogan เป็นรอกที่มีส่วนประกอบดีมากตัวนึ่ง ถ้านำมาปรับแต่ง จะทำให้นุ่มนวล เทียบเท่ารอกชั้นนำได้สบายเลยคับ

Modified Drag


The Previous Owner had changed the original drag washers out (Originals look like Super Smoothies) with these HT100 looking graphite discs.

This Drag pressure washer was mounted upside down when I opened the reel. That's probably why there was only a pound of drag at full lock, and the presence of the extra HT100 washer when there was no steel keyed plate to bite on.